Home > Die & Mould > Plastic Mould > News



Priamus System Technologies AG


Company \| News \| Products \| Contact Us

PRIAMUS: Easy Sensor Mounting with PRIAFIT®

9/17/2013

The use of cavity pressure and cavity temperature sensors directly at the molded part is a permanently growing market since many years. This is not surprising considering that a bad part cannot be detected only by machine parameters due to various reasons.

The sensors are therefore commodity items which are applied in high quantities.

And the ease of use during installation becomes even more important.

In the past decades two simple rules have been applied: a cavity pressure sensor was usually mounted with the help of a mounting nut in order to ensure an installation situation as stiff as possible. This is necessary to avoid measuring errors. A cavity temperature sensor however was clamped with the help of a distance sleeve as a standard because this has no influence on the temperature measurement. Both methods are not always ideal because the thread for the mounting nut must often be tapped deep in the bore hole and the distance sleeve must be cut to the exact length.

The new PRIAFIT® mounting sleeve consists of a combination of mounting nut and distance sleeve and combines the advantages of both methods. The thread for the mounting of the sensor can easily be tapped near the borehole top and the length of the sleeve must not be cut exact but only approximate. A simple but very efficient and cost-saving method.

Husky expands Altanium family with launch of Delta3 hot runner controller for two to 128 zones 7/17/2013

In Mold Labeling (IML) Pilot Cell at StackTeck 5/31/2013

Synventive Continues Expansion in Japan 7/17/2012

Novel injection moulding process from Mecaplast could cut car part weights in half 6/21/2012

SPE Thermoforming Division Announces Call for Entries in Parts Competition 5/9/2012

INCOE® Introduces NEW Valve Gate Tip Designed for Fast Color Change Applications 5/3/2012

INCOE® Introduces SoftGate® Advanced Sequential Control Performance to Global Markets 5/3/2012

INCOE® Expands "Request For Quotation" Program adding Temperature Controllers and Single Nozzle Systems 5/3/2012

INCOE® Introduces NEW Edge Gate System Technology 5/3/2012

Plastic Mould Exhibitions
	DMC 2026 7/1/2026 - 7/4/2026 Shanghai, China
	PDMEX 2026 7/23/2026 - 7/25/2026 Manila, Philippines
	Expoplast Peru Lima 2026 8/19/2026 - 8/22/2026 Lima, Peru
	Taipei Smart Mold & Die 2026 8/19/2026 - 8/22/2026 Taipei, Taiwan
	ANIPAC Convention 2026 9/1/2026 - 9/4/2026 TBD, Mexico
More Trade Shows